|
|
|
       |
 |
      |
|
Technical
Support - Hardware
Cisco ATA
INSTALLATION INFORMATION
Simple
plug and play Installation!
Follow
this 5 step process:
Installing
the Cisco ATA 186 (Analog Telephone Adaptor) for digital
long distance service is a simple 5-step process. Please
follow these steps and diagrams for guidance.
 |
Supports 2 RJ-11 phone jacks |
|
One RJ-45 10BASE-T E-net |
|
12V power connector |
|
Providing clear, natural sounding
voice |
|
 |
Plug & Play diagram for the ATA 186
Recommendation:
Place the Cisco ATA 186 near an electrical outlet.
Step
1
 |
Plug the telephone into the ATA:
Please connect the RJ-11telephone line to the PHONE 1
jack on the rear panel of the Cisco ATA 186. (Far Left)
The PHONE 1 input port is the primary telephone line.
If you only want one telephone line connected to the Cisco
ATA, please make sure it is plugged into PHONE 1… otherwise,
the system will not recognize the telephone and you will
not be able to access a dial tone.
|
Step
2
|
You can connect a second telephone to the
PHONE 2 input by using a second telephone line cord. The
PHONE 2 input is the secondary telephone line. You may
add this second line at any time.
|
Step
3
|
Connect one end of a 10-BaseT Ethernet cable
to your hub, switch, or broadband DSL or Cable modem.
|
Step
4
|
Connect the other end of the Ethernet cable
to the RJ-45 input port. This port is located on the rear
panel just right of the PHONE jacks.
|
Step
5
|
Plug the AC power adaptor into an electrical
outlet. Plug the power cord into the rear panel of the
unit … the plug input is located on the far right on the
back panel. Wait 15 seconds and pick up the telephone
receiver. If you can hear a dial tone you are ready to
place your first call using Cisco ATA 186.
|
If you do not hear a dial tone, please review
the instructions above. Unplug the electrical power for the
ATA. After waiting 10 seconds plug in the ATA and check for
a dial tone.
 For information on getting
your IP Address, click here.
Usually the installation process is simple, if there is a problem,
please review the ATA Troubleshooting Tips or contacts us promptly
via email. TPT's Technical Support is available from 9 AM ot
5 PM PST and our highly trained technical staff will quickly
return your email with information or contact you by telephone.
|
|
|
|
